The discharge particle size of quartz sand crusher is too large, which will
increase the subsequent processing load and affect the production progress.
Share practical solutions.
Firstly, check and adjust the gap between the discharge ports. Gradually
reduce the gap according to the target particle size. After adjustment, conduct
a trial run to confirm that the discharge meets the standard.
Next, check the wear of the hammer or jaw plate. If the wear is severe,
repair or replace it in a timely manner to avoid excessive particle size caused
by insufficient crushing force.
Finally, control the feed particle size to ensure that it meets the
requirements of the crusher, avoiding the entry of oversized raw materials that
may cause insufficient crushing.
Daily equipment inspections, timely adjustment of parameters, and replacement
of vulnerable parts can ensure stable particle size of crusher discharge and
improve production efficiency.