The wear-resistant lining plate on the inner wall of the cleaning machine
tank is a key barrier to protect the tank, but many customers have reported that
the lining plate wears through in less than half a year, and the tank steel
plate is directly exposed to quartz sand erosion, quickly causing pits and even
water leakage. Replacing the lining plate is time-consuming and laborious, and
not replacing it is afraid of the tank body being scrapped. The problem usually
lies in the lining material, impeller clearance, and fastening method.
Choosing the wrong lining material can accelerate the wear rate
exponentially. Under repeated erosion by quartz sand particles, the wear
resistance of ordinary rubber lining plates is significantly insufficient.
Polyurethane lining board has two to three times higher wear resistance than
rubber, and high alumina ceramic lining board has better wear resistance. The
appropriate material can be selected according to the scrubbing strength and
material particle size. When dealing with materials with high coarse particle
content, it is recommended to prioritize the use of polyurethane or ceramic
lining plates. Although the unit price is high, they have a long comprehensive
service life and low replacement frequency, making them more cost-effective in
the long run.
The gap between the impeller and the lining plate is too large, causing the
material to rapidly wash the lining plate in the gap. The standard clearance
between the outer edge of the impeller and the lining plate of the groove should
be controlled between 5-8mm. When the gap is too large, the slurry forms a
strong vortex between the impeller and the lining plate, and the sand particles
repeatedly impact the surface of the lining plate, greatly accelerating the wear
rate. Stop the machine once a month to measure the gap, and adjust the impeller
position or replace worn parts if it exceeds the standard. When the impeller
itself is severely worn, the dynamic balance deteriorates, causing deflection
during operation and exacerbating local wear of the lining plate.
The fastening bolts of the lining plate are loose, and the lining plate is
lifted and directly impacted by the material. The lining plate is fixed to the
inner wall of the groove by countersunk bolts. After long-term vibration, the
bolts loosen, and gaps appear between the lining plate and the groove. Sand
particles drill into the gaps and repeatedly squeeze, causing the edges of the
lining plate to lift up and be directly washed away by high-speed materials,
quickly breaking and falling off. Check the fastening bolts one by one during
each shutdown maintenance, and replace the bolts with new ones if the
countersunk head is severely worn. When installing a new lining plate, the bolt
head should sink below the surface of the lining plate to avoid direct wear from
the material.
During daily inspections, use a thickness gauge to check the thickness of the
lining plate once a month. If the wear exceeds half of the original thickness,
arrange for replacement. Encountering problems during equipment operation,
welcome to contact the technical team of Shandong Heavy Industry for
communication: Manager Zhang 13583776655 (same as WeChat).