News center

Company News

What should be done if the inclination angle of the dewatering screen surface is not adjusted correctly and the dewatering effect is poor?

2026-11-17

The inclination angle of the vibrating dewatering screen may seem insignificant, but it directly affects the residence time and dewatering effect of the material on the screen surface. If the inclination angle is not adjusted correctly, either the material runs too fast and the moisture cannot be discharged in time, or the material accumulates too thick to be processed by the sieve surface. Many customers repeatedly adjust the feeding amount and vibration parameters, but have not adjusted the tilt angle, so the problem cannot be solved naturally.

A too small inclination angle and a too long material retention time can actually be a bad thing. When the screen surface is flat, the material moves slowly on the screen surface, and the material layer becomes thicker as it accumulates. The bottom layer of material is pressed down by the upper layer, and the water cannot penetrate, resulting in serious water leakage on the screen surface. When the inclination angle is below 5 °, the material may even stagnate on the screen surface. When dealing with quartz sand with high content of fine powder, it is recommended that the inclination angle should not be less than 7 ° to maintain stable movement of the material.

The inclination angle is too large, and the material flashes through without enough moisture to pass through the sieve. When the inclination angle exceeds 12 °, the material quickly slides down along the sieve surface, and the time it stays above the sieve hole is insufficient. The moisture is carried away by the sand before it can pass through the sieve hole. The moisture content of the discharged material is significantly higher, and the amount of water sieved decreases instead. When dealing with materials mainly composed of coarse particles, the inclination angle can be appropriately increased by 10 ° -12 °, but should not exceed 12 °.

Adjusting the tilt angle requires gradual trial and error, and cannot be done all at once. First, set the inclination angle of the sieve surface within the range of 7 ° -8 °, and observe the moisture content of the discharged material and the water running on the sieve surface. Reduce the moisture content by 1 ° each time when it is too high, allowing the material to stay for a while longer; When there is severe water leakage on the sieve surface, increase it by 1 ° each time to make the material move faster. Run for 2 hours after each adjustment to sample and test the moisture content of the discharged material until the optimal angle is found. When adjusting, pay attention to checking whether both sides of the screen surface are horizontal at the same time. Inconsistent left and right inclination angles can cause the material to lean to one side, which also affects the dewatering effect.

The adjustment bolt for the inclination angle of the screen surface is usually located at the connection between the screen box and the base. Loosen the locking nut and rotate the adjustment screw to change the inclination angle. After adjustment, be sure to tighten the nut to prevent angle deviation caused by vibration during operation. Encountering problems during equipment operation, welcome to contact the technical team of Shandong Heavy Industry for communication: Manager Zhang 13583776655 (same as WeChat).


Return
WhatsApp QR code