News center

Company News

Why hasn't the jaw broken and the discharge port been moved, but the discharge is getting thicker and thicker?

2026-11-20

The jaw crusher is responsible for coarse crushing at the front end of the quartz sand production line, and the particle size of the discharged material directly determines the load of subsequent grinding or sand making. Many customers have encountered a strange phenomenon: the discharge port adjustment device has been adjusted to the minimum position, but there are still a large number of oversized coarse particles mixed in the discharge, and the amount of material returned on the screen remains high. The problem often lies not in the adjusting device itself, but in the easily overlooked aspect of jaw plate wear.

After grinding the teeth of the jaw plate, the actual discharge port is slightly larger than the set value. The discharge port size of a jaw crusher refers to the distance between the tooth peaks of two jaw plates. The teeth of the new jaw plate are sharp, with distinct peaks and valleys, and the amount of material discharged is determined by the number of discharge ports set. After running for several months, the tooth peaks gradually ground flat, the tooth valleys were filled with materials, and the jaw plate working surface became smooth. At this point, although the discharge port value displayed by the adjustment device has not changed, the actual minimum gap between the two jaw plates has quietly increased. Experimental data shows that in the later stage of jaw plate tooth wear, the actual discharge port can be 5-8mm larger than the set value, and the proportion of oversized particles in the discharge significantly increases.

When the wear of the jaw plate is uneven, the discharge port is not consistent along the width direction. When the feeding is biased towards one side, the jaw plate on that side wears out faster, and the discharge port forms a wedge-shaped gap along the width direction of the crushing chamber - one side is tight and the other side is loose. The material leaks directly from the loose side, and the particle size naturally tends to be coarse. During inspection, use a caliper to measure the actual clearance of the discharge port at multiple points along the width direction of the crushing chamber. If the deviation exceeds 3mm, it indicates uneven wear of the jaw plate and requires adjustment of the feeding distribution or replacement of the jaw plate.

Loose or displaced jaw plates can also alter the actual discharge port. The jaw plate is fixed on the jaw bed by wedges or bolts. After long-term vibration, the fasteners loosen, and there is a gap between the jaw plate and the jaw bed. During the crushing process, the jaw plate moves slightly backward, and the actual discharge port increases. Check the jaw plate fastening bolts and wedges during each shutdown maintenance, and tighten them evenly in diagonal order. If there is material embedded in the back of the jaw plate and the joint surface of the jaw bed, it will also cause the jaw plate to be installed improperly. Thoroughly clean the joint surface before installation.

To determine whether the jaw plate needs to be replaced, one should not only look at the wear time, but also use a caliper to measure the tooth peak height. When the tooth peak is ground to more than one-third of the original height, even if the discharge port is adjusted to the minimum, the discharge particle size cannot be controlled within the set range. Encountering problems during equipment operation, welcome to contact the technical team of Shandong Heavy Industry for communication: Manager Zhang 13583776655 (same as WeChat).


Return
WhatsApp QR code